A Jaipur‑bound air india flight (AI‑1719) experienced a dramatic touchdown attempt at Jaipur International Airport on Thursday, when the aircraft touched the runway but then aborted the landing and took off again before safely landing on its second attempt.

🛬 What Happened During the Landing Attempt?

The flight, en route from Mumbai to Jaipur, was making its approach to jaipur airport when the pilots attempted to land.

However:

The aircraft touched down briefly on the runway, then immediately took off again — a maneuver known as a “go‑around” or aborted landing.

It remained airborne for a short period before executing a second, safe landing after conditions were re‑assessed by the flight crew.

🧑‍✈️ Why Was the Landing Aborted?

According to preliminary reports from airport sources:

The landing became unstable during the final approach, meaning the aircraft’s speed, data-alignment, or descent rate did not meet the strict safety criteria needed for a safe touchdown.

In such cases, airline procedures require pilots to abort the landing and perform a go‑around to ensure passenger safety.

After staying airborne briefly and circling the airport, the aircraft lined up again and landed safely on the next attempt.

This is a standard safety response in commercial aviation whenever conditions aren’t ideal for touchdown — and it’s used widely by pilots worldwide.

👩‍✈️ Passengers and Reactions

There were no injuries reported, and all passengers — including senior congress leader Sukhjinder Singh Randhawa — remained unharmed.
The initial aborted landing naturally caused momentary concern among passengers and people waiting at the airport, but relief followed once the aircraft landed safely on the second attempt.

Airport officials confirmed that all standard safety protocols were followed throughout the event, which helped ensure that everyone on board remained safe.

🧠 What Is a Go‑Around and Why Is It Done?

A go‑around (or aborted landing) is when a pilot discontinues a landing attempt even after briefly touching down or nearing the runway. This can happen due to:

✔ Unstable approach (speed or data-alignment not matching required parameters)
✔ Crosswinds or gusty winds
✔ Visibility issues
✔ Runway conditions or air traffic safety requirements

In such cases, pilots are trained to pull up and circle back for a safe landing instead of risking a dangerous touchdown.

This practice is considered a proactive safety measure in aviation and is a routine part of pilot training.

✈️ Is This Uncommon?

Aborted landings happen occasionally at airports around the world and are not usually a sign of a major emergency — especially when the flight safely lands afterward. Similar go‑arounds have occurred in india and globally under varying conditions, such as unstable approaches or weather‑related challenges.

While the event may seem dramatic, the priority is always safety first — and pilots will always choose to go around rather than risk a risky touchdown.

📌 Quick Summary

A Jaipur‑bound air india flight touched the runway but aborted landing and went airborne again due to an unstable approach.

The aircraft landed safely on its second attempt about 10 minutes later.

No injuries were reported, and safety protocols were followed throughout.

Such go‑around procedures are standard aviation safety practices used when a safe landing cannot be ensured on the first try.

 

Disclaimer:

The views and opinions expressed in this article are those of the author and do not necessarily reflect the official policy or position of any agency, organization, employer, or company. All information provided is for general informational purposes only. While every effort has been made to ensure accuracy, we make no representations or warranties of any kind, express or implied, about the completeness, reliability, or suitability of the information contained herein. Readers are advised to verify facts and seek professional advice where necessary. Any reliance placed on such information is strictly at the reader’s own risk.